MIL-DTL-46796D
belt deterioration, or any sign of water entry resulting from above testing, shall be cause for
rejection.
4.6.14 Exterior surface treatment. To determine conformance to 3.9, the engine
assembly shall be examined to assure that there are no exposed bare metal surfaces, except for
mating mounting surfaces.
4.6.15 Engine nameplate. As required by 3.10, verify that nameplates, data and
instruction plates shall conform to manufacturer s specifications or to applicable drawings.
4.6.16 Workmanship. The engine assembly shall be visually examined to verify that the
workmanship at all phases of fabrication, assembly and test meet all specified requirements
(see 3.11).
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as
specified in the contract or order (see 6.2). When actual packaging of materiel is to be
performed by DoD personnel, these personnel need to contact the responsible packaging activity
to ascertain requisite packaging requirements. Packaging requirements are maintained by the
Inventory Control Point s packaging activity within the Military Department of Defense Agency,
or within the Military Department s System Command. Packaging data retrieval is available
from the managing Military Department s or Defense Agency s automated packaging files, CD-
ROM products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful,
but is not mandatory.)
6.1 Intended use. The engines covered by this specification are intended for production
use as spares or replacements for military combat and tactical vehicles. Due to the extreme
environmental conditions under which these engines must perform (-25F to 115F (-31.6C to
46.1C)), up to 100 % humidity, and up to 8000 ft (2438 m) above sea level, conditions that
would cause catastrophic failure in commercial counterparts, this item is military unique
(see 1.1).
6.2 Acquisition data. Acquisition documents should specify the following:
a. Title, number, and date of this specification.
b. If required, the specific issue of individual documents referenced (see 2.2.1, 2.2.2,
and 2.3).
c. If first article samples are not required (see 3.1).
d. If electrical accessories and equipment are not required (see 3.4.1)
e. If preproduction inspection is required (see 4.2.1).
17
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business